The Dust Xtractor
Dust Tiger Cutting Attachment
With the DUST XTRACTOR, you get the ultimate protection from silica dust when cutting in place..
Are you sick and worried of inhaling too much harmful silica dust? If so, then you need to get your hands on the Dust Xtractor, cut in place attachment. This attachment is the ultimate solution to the protection from silica dust. See why your crew may want this saw attachment!
Why The Dust Xtractor?
Precise Cut
The Dust Xtractor is an attachment that provides suction of the dust while cutting which results in a more precise and accurate cut.
Keep Your Saw
Whats better than cutting without any silica dust? Cutting with your own personal saw. With the Dust Xtractor, this is possible.
Peace of Mind
The best way to cut is knowing it is protected under OSHA’s safety guidelines. Cut knowing you and your crew have taken proper measures for the prevention of silica dust.
Dust Xtractor Attachment
You Have a Choice
Why continue to damage you and your crews lungs by inhaling silica dust? Get the prevention from silica dust that is OSHA approved for your jobsite. See the other saw attachments like the Dust Tiger, and the Dust Shark to find the right saw attachment for your crew.
More About The Dust Xtractor
Use the Dust Xtractor for cutting pavers in place or cutting control joints in concrete. It may be used on both curved and straight cuts, and the saw blade does not need to be fully plunged to capture the dust. A non marking wear plate is installed on the bottom. It attaches to a Stihl or Husqvarna cutoff saw and can be quickly installed or removed. It shares the same mounting bracket with the Dust Shark. A minimum of 400 cfm and 6” hose are recommended. The Dust Extractor will enable you to meet Table 2 requirements in the OSHA Respirable Silica law.
